WHAT TO EXPECT

 

Great Expectations

We recommend using i-LIGHT Pro every two weeks for the first three sessions. After that, use it only as needed when hair begins growing back. Here is what you can expect to experience and feel during a treatment.

 

What to Expect During i-LIGHT Pro Treatment

• A Flash of Light: the Skin Contact Sensors ensure that most of the light is directed into the skin. The remaining visible light will not harm the eyes when applied to non-facial sites, and special eye protection is not needed as long as you follow directions in the Use and Care Guide.

• A Sound with Each Flash: When a flash of light is activated, it is normal to hear a subtle "pop" sound as the i-LIGHT Pro flashes.

• A Sensation of Warmth and Tingling: Actual sensations felt by users will vary by person and body part being treated. Many people describe each flash like a rubber band being lightly snapped against the skin. Always start out at the lowest energy level and work your way up one level at a time. If the sensation is too intense or painful, revert back to lower power levels.

• Some Mild Redness: During and just after your IPL session, it is not uncommon to see some very mild redness, mostly noticeable around the hairs themselves. This is normal and typically clears up within a few hours. Do NOT flash the same area of skin multiple times within the same session.

 

For complete list of Risks, please refer to your Use & Care Guide.

 

 

Treatment Breakdown

• You should complete your first three treatments every two weeks to ensure that you have hit all hairs in the growth phase in the targeted area.

• After the third treatment it's important to continue your treatments only as-needed to target hairs that have recently entered the active cycle.

• Repeat the process for every body part with unwanted hair.

 

 

 

RESULTS

 

Making Hair Removal Simple

 

The i-LIGHT Pro System is designed to make your life easier with results that last months*. Now, with these tips and tricks it's even easier to get the best results from your i-LIGHT Pro.

 

i-LIGHT Pro Tips & Tricks

 

1. Shave immediately before treating the area to minimize the sensation felt from the flashes. With less hair to heat up the treatment will sting less and allow you to use a higher energy level. IPL works below the skin, so the system is still effective even if hairs are not clearly visible above the skin surface. After shaving, wipe the skin clean and completely dry the area before using. How close you shave will make a big difference in how the treatment feels.

 

2. If you've waxed, tweezed or epilated the hair in the treatment area, wait 6 weeks before using the system. IPL treats the hair under your skin to disable your hair follicles, so it is not effective if the hair has already been pulled out.

 

3. Higher energy levels are more effective. We recommend starting out at the lowest level and only increasing by one level at a time. While higher levels may be more effective, they may also be less comfortable. Use the highest energy level setting that's comfortable for you. If flashing the device feels uncomfortable, take a break from treatments and allow the device and your skin to cool down before starting again.

 

4. Work each treatment area in an organized, grid-like pattern to ensure that you cover all the hairs in the intended treatment area. Do NOT flash the same spot multiple times during the same session.

 

5. Stick with the full treatment for each body area.

 

6. For faster coverage hold down the FLASH BUTTON while you lift the HANDPIECE and place it back in contact with the new area to be treated. This will cause the unit to deliver a flash to the skin within about 2 seconds when full contact between the skin and the HANDPIECE is established.

 

 

*Individual results will vary. In clinical testing, on average, participants had 47.8% fewer hairs six months after just three treatments, similar to results observed from professional hair removal systems.